The one from the diode inspector is what I'm using (and I see a request from back in April for a small signal diode part from someone else with no replies) but while the spacing looks to be 0.300" it appears in the breadboard view as 0.400" which is sensible for a 1n4001 as I don't think you can easily bend it to fit into 0.300".
It sounds like from the other post that the PCB hole size is too large (again sensible for a 1n4001 as it is higher current than the small signal diodes) as well although I'm not worried about PCB at the moment.
↧
Small signal diode part?
↧