Doing a save (without any changes) of the diode part from the part editor indeed gives me a .svg file with the field "rect x="0.011" height="1" fill="none" width="1" id="connector0pin" gorn="0.0.0" y="2.583"
in it, but it is unclear to me how I would edit this to change the spacing from .4 to .3. I guess I need to try one of the create your own part tutorials (although I saw somewhere that with the editor changes the tutorials are out of date). Is there documentation somewhere that I haven't found yet on the various file formats in use?
↧
Small signal diode part?
↧