Hey everyone,
I’m looking for a way to create fancy looking faceplates for a synthesizer using PCB. Since Fritzing does not have editable layers, modifying the copper layer or solder mask layer is a challenge.
I have two questions:
- Any idea if it’s possible to add svg graphics to the solder layers?
- Is it possible to modify the solder mask, so the copper is seen through?
Here is an example board design:
Bottom copper - connecting all components
Bottom copper - the black lines are also on that layer. They don’t touch the actual components, but they are visible.
Solder mask - where you see gold lines, that’s the top copper layer is visible
Thanks!