I have an SVG that the parts editor doesn't display the graphics when i select "load image .." in the parts editor. The page border of the image is shown as a highlighted area in the parts editor window, but the graphics do not show. The graphic is a 3D drawing which was exported from solidworks to a .AI format, then imported into inkscape and saved at plain SVG. I do not get any error messages. Does anyone have experience pulling graphics from Solidworks into a format the parts editor will open?
I'm new to this community and havent figured out how to post my file, but i am happy to share it if someone would take a look.
Thanks,
Chip