Old_Grey... I really appreciate your time looking at this.
That is not a correct assumption.
Yes, C1 is connected to VCC -. I set up the BB, SCH and PCB views and saved it as a starting point for all sketches (so I wouldn't have to keep redoing them). You may be referring to the PCB view. It's only the label for the 2-pin input header in that view that needed flipped (the pin numbers for that header are consistent across all views).
As I stated, both SCH and PCB agreed with each other until I laid out the BB view. I kinda agree with you on not messing with BB view, as it is the one that threw the other two off, but then there would be no reference to test the circuit before any soldering took place. To me, that's a bug in the software.
Also, try this...
In SCH view, delete a rat nest line (if Fz will let you). Then look at BB view. Fz throws the component completely off the breadboard and connects it with wires... Even if you have the component 'locked' in that view. Why ?? That is a problem.
Again, thank you much for your time.