Hi!
I am making a HAT pcb for RPi Ver.3.
1st question:
How can I make the holes of the resistors smaller?
They seem to be on the default 1mm, but I need them around 0.7-0.6. There is no option when I click on them.
2nd question:
How can I make a wire partly smaller, and then bigger again?
On the 40pin connector, some wires need to be small, in order to fit-pass between the second line of connectors.After that, I want them to be bigger again, cause I am afraid of voltage drop on a constantly slim wire.
In the picture below, I need the section of wire in the blue circle as it is, and the rest of the wire bigger.
3rd question:
Is there a problem with close to another wires?
In the picture below, the dotted line from one wire, intersects with another wire. Am I going to have a problem with them being too close to eachother?
