Over all pretty good, but as Old_Grey said, your connectors aren't right. Using gerbv (from the geda project) to look at the gerbers (created via file->export_>for production->extended gerber to get the gerber files) your square pin on pin1 isn't correct the circle is bigger than the square and the holes are wrong (.052 on the square and .030 on the others, should be .038 for .25 inch square pins if that's what you want to use. The 7pin version appears to have the same sequence number as one of the first two as Fritz tells me it is already loaded when I have the 3 and 4 pin ones already loaded. Again as Old_Grey mentioned the connectors in schematic are connecting in the center (which is the default). In theory (and as shown in Old_Grey's video tutorial on parts creation) you can set this to the compass directions (south in this case I expect) in the new parts editor. Despite his advise and tutorials I haven't been able to make that work so in the mother of all parts I'm cheating and setting the terminals in the svgs as pins on .02 rectangle and terminals on .01 rectangles which makes for a small red dot but at least works how I want it :-). If you are using Inkscape for your svg editor I can tell you how to change the hole sizes in the svg (and the distorted pad may be because of translates which I now know how to eliminate as well.
↧