By and large looks fine, a couple of minor points. In the pcb svg copper0 should be under copper1 (doing an indent node on the copper0 group will fix that) the result is you only have a copper0 (bottom) pad in the gerbers, the top pad is missing.. Your hole sizes are a little non standard. the terminal holes show as being 0.511 (1.3 mm) in the pdf but are 0.066743 in the gerbers, my list of free drill sizes from a local pcb supplier indicates .0520 or .0595 as free drill sizes so you may want to switch to one of those (and.or check with your favorite fab house for their list). For the mounting hole, .125 shows as a free size so you may want to switch to that (although the current 0.106 matches their hole, larger by a bit shouldn't hurt).
↧
