Looks not bad, but on schematic RB6 and RB7 have no active connections (although the pins exist) and they don't appear anywhere on the breadboard side. It may be they are in use by the Poc18Lf25k which I assume is the USB/cloud connection (in which case perhaps they should be omitted from schematic).
It looks like schematic has pins only (no terminals) and thus a connection at an angle to the pin connects to the center of the pin. If you define a terminal and place it at the end of the pin then the wire will correctly bend around the end of the pin. The VSS /EP pins in schematic connect to something (I assume probably ground) but it isn't a real connection in Fritzing and EP connects to a pin marked GND in breadboard one or the other label should probably change. Assuming (as is probably the case) that all the grounds are common, you may want to add a bus to the fpz file to interconnect all the grounds as well as the 3.3V and 5V pins (which again I assume are likely common).
Peter