Thanks very much again, already sent for production. part size is perfect, pin size is same as LED pin. The connection hole in your part seems to be larger than the LED hole size so it should fit. The layout is correct, pin#1 is at 1 o'clock on the PCB!. Curious though, had seen all the videos by Old Grey on parts creation and just reread fritzig help on new parts editor, to gain some insight on this, went to "edit (your) part"-"connections" added a pin 5 then "PCB"-clicked #5 - "select graphic" all I get are long crosshairs! It doesn't choose the pin as a connection. There is a tiny white dot in the center of the connection and when I now click pin #5 again a small black circle surrounds it. Do I have to go into Inkscape to do it? One would think if "edit-parts" allows you to get crosshairs and position it over the connector it would also allow you to choose it and make it active.
thanks again can't wait for the board to come, couldn't have done it without you!
Les