Dear Vanepp,
You are just amazing. Im actually trying to get my current build recitifed. But im facing certain difficulties. I have uploaded my fritzing data here. The component im trying to replace with is the one i show below. But im unsure if i have to redo the entire circuit or if i can simply replace the component footprint with your footprint, the one used in the PCB design file attached below was the 4mm one. I am going to be hand soldering it either with a heat gun or some SMD soldering tricks. I have done it before using a heatgun and soldering iron on breakout board. but this being a 4mm version i was not able to solder it. i wish to rectify it. Would you have advice?
Acquisition Module Mark 1.fzz (495.8 KB)