Steps I took that resulted in the problem:
during the build of a board, i was trying to place holes in designated spaces according to a Hensel junction box data sheet (Attached). i placed the holes on the board according to the X and Y coordinates for the holes i wanted to use.
...
What I expected should have happened instead:
i expected the holes to be in the proper position according the Hansel data sheet. the holes are off and when i hover over the location of the holes the X Y coordinates listed at the bottom right of the window are off by a few mm.
...
My version of Fritzing and my operating system:
Fritzing 0.9.3 Beta
MacOS X 10.11.6
...
Please also attach any files that help explaining this problem
large_Controller.fzz (14.0 KB)