Sorry about that; I thought I read that you were good in designing and drawing... guess I overlooked the "not" part. Sucks getting old... Thought that I could make a coupe of parts for you and you could make the rest... (see one, do one, teach one).
As far as I am aware, no one has made any array resistors for FZ, and If someone had made them a long time ago they would't work anyway...
The smd array-4 appear the be the most common array resistor, although it come is various packages... Each one of these needs to be a separate part. To make each package in a number of arrays you can multiply that by each package... then multiply that number by types... Then you have through hole... well, you get the picture. Some FZ core part (like connectors) are generated by a parametric script to generate the number of pin required, Unfortunately, I don't have the knowledge to write the parametric resistor array script for FZ, so I have to make individual parts.
When I make a part for someone, it needs to be fully functional so it can eventually be added to the core parts and everyone can use it.
FZ has also added SPICE modeling information to Fritzing parts. This is use for the resistor value selection, I believe It can added it to the array resistors... but of course only one value can be selected.
What I have gathered so far, is that this project you are working on is all tht and there are no smd components on it at all... Is that correct? Is the a project where you are going to make a pcb or do you just need the breadboard view for some kind of presentation...