I took the gorn's out... they are not needed, FZ generates them and when I use files that FZ generate in CorelDraw, the gorn is labeled as svg tags of some kind and cannot be extracted from the element. The only way I can delete them is in a svg editor. Most of the time I just leave them in as they don't normally cause a problem.
Attached is the part file for a 3-pin Bussed, I have been screwing around with it for hours trying to figure out how the get the "spice" to work for the resistance and tolerance. It keep jumping back to the single resistor. This works under the family "resistor" along with the other resistors. You probably understand this better than I do. If we can't tap into the spice for the single resistor, then may need to use a new family name like "resistor-array" for both the Bussed and Isolated and write a new spice. Supposedly you can create your own spice, I just don't know how.
You can load this file into FZ and see what I mean. Get this down to a science then we can work on the smd packages. 
Resistor Bussed 2R.fzpz (6.8 KB)