My brain just can not program anymore... heck I doubt that I could figure out how to clear the buffer after a printf command.
I spend most of my time in a facebook group called
3D Printer Builders/Designers
And I ended up here because I wanted to put all my limit switches on one pin with led indicators... it turns out my circuit was fine... however, there wasn't enough mA to run 8 leds on one pin.
We use a arduino with a RAMPS board to control the 3 axis and up to two extruders.
So now that I see that you have added arduino I am sure that many people will find that to be an asset to their hobbies.
If I was younger and still able to program I would include ohms law into the parts / program so when students plugged in the parts they could see the power resistance voltage values etc... this would in my mind attract a lot of people that understood the math but didn't want to do so much math...
However, the amount of work to create such a software would be vast.
For me, it is perfect it help me so I can drag wires around and find a wiring route that didn't require jumpers.
It is also good for someone that wanted to make their own PCB
I am sure that I will make a PCB just because of this software.
take care everyone