Hi, I am looking for some help creating a part for the 19885RGB 8x8 LED matrix module. The data sheet for this module can be found at this link. The data sheet doesn’t clearly indicate it, but pin 1 is the lower right pin looking from behind (lower left pin looking from above) and pin 16 is the lower left looking from behind. Also note that the unit drawing in the data sheet doesn’t appear to be to scale for the pin placements. The actual measurements are correct, but the drawing makes the pins look too close together with respect to the unit’s overall width. But again, the number values for the measurements in the data sheet are verified to be correct (2.54mm *15 does equal 38.1mm) . Here is an image of the backside pins to accompany the data sheet:
Any help would be appreciated. Thanks!