[Rather than updating my last post, I’m doing via a Reply]
I updated/changed my files to reflect:
• All file’s:
Changed Hole Stroke-Width=0
• Schematic’s
• Terminal End connections
• Changed graphic to Box with single-lines (not Y )
• Changed sequential numbering to Duplicated 0-8
• PCB’s
• Holes: changed ID to ‘noconn’
As said/shown in previous post, all files have correct layer names and ID’s. I opened them in several different editors (xCode, BBedit, eclipseNeon, OpenOffice, TextEditor) all show ID’s correctly.
Exported them from Fritzing.
I think the only remaining thing for me to understand/change are the ‘Scaling’ you referred to… However, given that, in Inkscape, 96px = 1inch, logic suggest scaling them by 1.0427. Rather than rescaling for these re-posted parts for you review, I’ll wait for clarification of ‘scale’…
And, any ID’s that you mentioned where I may be missing a point you’re making (sorry, old and slow).
Thanks again
Nokia 5110 INK Display_v1.fzpz (12.0 KB)
Nokia 5110 INK Display_v2.fzpz (11.9 KB)
Nokia 5110 INK Display_v3.fzpz (13.6 KB)