Thank you for taking time to look at my circuit and fixing it. I did indeed move the pixel strip in the schematic view. Because I noticed the pins were green but the ground wasn’t. So I moved it and the lines appeared but the ground pin still isn’t connected. Is that right? because I have the ground pin connected into ground on my breadboard. Thank you for the advice I will try and keep my traces horizontal and vertical with 45 degree angle connections. I have an idea the size of my enclosure will be, but not exact yet. I am going to try and make it as a shield for the mega. The reason why I have my pixel ring on top of my pot is because that is how the final design is going to be. the pot will go through the pixel ring. But I think I am going to connect them by using wires from the pcb.
I’m sorry I don’t fully understand what you mean with point 4.
As noted the neo pixels take high current so their power leads should be separate from the power leads to the rest of the circuitry and be as wide as possible (to increase their current carrying capacity. I would actually not put the power wires on the board at all but run a large gauge wires from the power supply to the ground and +5V pins on the neo pixels. In all you look to be doing pretty good
.
.