Hello peter,
it is not possible to get the data sheet because the MIDI interface is made in Italy and all components are sent to France to be installed in the accordion factory maugein. Anyway I keep my sensors and I will install my sensors on the printed circuit boards. I found a solution to fix the magnets is the main one and I have a little margin to move them. It was really the big problem that I had not analyzed enough! I will use plastic dowels with a diameter of 4 mm (see my picture) I must find exactly the same dowels. I will use if necessary dupont connectors to extend my legs on some sensors but I do not think so. Mr Tom scarff sent me today the source code (INO source file) of my Arduino card. We’ll see what we can do for that it’s not important for now. Good thank you in any case for your work! Take care of your other project and if you have the time send me the project of the right hand if possible. I think that should be good for the left hand too. Thanks again for your cooperation
philippe
