I would like to create a custom shaped "copper plane" that i can then use as a "bus", that will have traces terminated to the bus along its length. I've had success using the copper blocker feature to create the 'bus plane' by trapping the fill between blocked zones, but i cannot figure out how to route traces to the plane along its length. I do see the red dot in the corner of the plane, and i can connect to that. Is this the only place i can connect to the plane? I could add a via, but that seems odd, since i really dont need a hole, i just need connections to the copper fill at a convienient locations. Perhaps there is another feature i need to add in combination with the copper fill?
Thanks Chip