There are actually a few more problems than that. There is a bus on pins 1 and 2 and 3 and 4 which short pin 1 and 2 and 3 and 4 (and since 1 is +5V and 2 is gnd, I'm fairly sure this wasn't intended and is a holdover from the cloned part Image may be NSFW.
Clik here to view.
). As Old_Grey noted the pcb is in rough shape, no copper1, various pins have incorrect names in the various files. I've cleaned most of that up, but connector30pin (the 3.3 V output) is giving me grief. It is missing its terminal entirely in pcb view and is grouped oddly compared to the others and I haven't yet been successful in getting a configuration that works (I may just try deleting it for now to see if the rest works). If I can get a config that mostly works (the pcb is going to be difficult to fix totally without a board), I'll post it here for you. The breadboard view is a work of art and mechanically accurate as well as far as I can see. It only needed to be aligned to the .1 grid so it lines up correctly.
(Edit: My bad, its schematic view that is missing the terminal for pin 30 not pcb).
