I'm trying to create 4 pin header with 0.375in pin spacing on my PCB. This is to interface with an bunch of odd sized ribbon cables on the gadget I'm trying to modify.
I figured I could use the generic Female Header and set the pitch, but it seems that the pitch is restricted to the a preselected set in a drop-down? Is there a way to set it to 0.375" pin spacing?
I tried editing the part, but after opening it up in the (new) parts editor, I was unable to modify the PCB at all.
Alternate suggestions are welcome too. I just want 6 lines of 4 holes on my PCB with 0.375" in spacing.
