Auto-relocating of part placement problems

Yeah I know. I put a request for bigger X,Y coord box and a ruler as a patch, but that was a while ago.

In actual fact if you could position stuff perfectly in the drawing, that actual machining centre can't drill it in the perfect position, because it has a tolerance.

If this is a thing that you will use a lot, you could make it a part. I went through this last week with my DENSO ECU connector, and I could get the svg perfect dimensionally. But when I checked the exported gerber it wasn't perfect - the error averaged out 6/10,000 of a mm -, but that could be the conversion of units.

It was out about 6 - 1000 of a mm ADV, now it's 6 - 10,000 of a mm.

Gerber - Actual - ABS Difference
3.50012 3.50000 0.00012
3.50012 3.50000 0.00012
3.09880 3.10000 0.00120
2.99974 3.00000 0.00026
3.00228 3.00000 0.00228
2.99974 3.00000 0.00026
2.99974 3.00000 0.00026
2.99974 3.00000 0.00026
3.00228 3.00000 0.00228
2.99720 3.00000 0.00280
3.10134 3.10000 0.00134
3.50012 3.50000 0.00012
6.20014 6.20000 0.00014
3.09880 3.10000 0.00120
2.99974 3.00000 0.00026
2.99974 3.00000 0.00026
3.00228 3.00000 0.00228
2.99974 3.00000 0.00026
2.99974 3.00000 0.00026
2.99974 3.00000 0.00026
2.99974 3.00000 0.00026
3.09880 3.10000 0.00120
3.50012 3.50000 0.00012

The node coordinates are perfect in INK now, so I assume it must be the conversion in the Gerber from inch to mm.

Old drawing had mysterious XML somewhere, so the problem is solved by making a new one.