It is likely the one at T105C0.038000 the T105 is the label for the pins, the 0.0380000 is the hole size. There are a lot of odd looking hole sizes in this sketch it may be a good bet to check the rest look reasonable. You can find the x/y coords in my case it looks like this
T100
X013896Y029911
X004400Y029911
X006400Y016911
X012400Y029911
X015396Y029911
X010900Y029911
X005896Y029911
X002900Y029911 which corresponds to this one in the drill file
X007396Y029911
X008401Y016911
X007401Y016911
if you move to the listed x/y coords in your gerber viewer that will identify which hole it is referring to.
Peter