A couple of suggestions: in breadboard you want to change the connectorxpin labels on connector 0 to 3 to the larger circle (which currently have the pin names) because if you connect a wire on breadboard, vcc (the bottom one) is normal but the other 4 have a large green or red halo. The cause seems to be that the connector pin is to the smaller circle on the connector which for some reason causes a large halo. In schematic view you want to add connectorxterminal pads at the end of the pin because at present the schematic connections go to the center of the pin (because there is no terminal defined). I usually use a .02 inch rectangle for the terminal pad. Other than that looks good.
Peter