I hope, that I have understood you correct. I have removed the inner circle and made the connection to the outer circle now.
ESP8266-05.fzpz (7.5 KB)
I had made the connection in schematic view correct to the end of the pin, But uploaded the previous version, where connection was in the center. The reason for this is, that when I make a new version, it automatically gets a new variant number. I have found out, that this new variant number is not necessarily the highest. It is quite annoying. The new variant does not get its new number before you have closed Fitzing. So you do not know it on beforehand. And you can not delete the old version, while it is used in the project. Even you delete the part
in the project.
You have to notice the variant number of the old one before you close your project in order to delete the correct one next time you start Fitzing.