Alright, yeah that makes sense my bad. I will try that after. Got ten pedals set out. I haven't set anything to the tenth pedal yet as I need to write and figure away how to use midi bank to like change a preset or something. I know that these jack sockets the legs are connected to one another at either side. Got them all connected into the breadboard and they all seem to work. Set them just like the push buttons but had to change the jump wire from the top left to the top right for it to work. Checked each one in midi monitor on my mac and everyone says off then on when pedal is pressed. I think this is because they are actually sustain pedals. I don't really want to use shift register for the pedals. But I definitely need them for the LED's. Next task is to get these led's sorted, but I still haven't recieved my shift register chips which is a little annoying. A guy Suggested I use bi coloured led's.
↧