I finally downloaded the file, you created and had a look. Thank you for clarifying what the power hookups are supposed to look like and the difference between the +12V, GND and -12V.
I relabeled the components and started to move components around in the breadboard view and what I noticed was that there are still rats nest lines that appear across resistors regardless of how I orient them. When I deleted these rats nest lines, it deleted traces from the schematic...so that now the schematic appears with un-routed nets.
Is the deletion of the rats nest lines an issue? Does a RNL across a resistor mean that I have to put a jumper across the resistor? I have spent a lot of time on this. Is Fritzing in fact able to model analog circuitry?