That looks better Image may be NSFW.
Clik here to view.
. Still two minor problems: the icon is still 8 pin, to fix that either copy the breadboard.svg file to the icon.svg file (using the correct file names) or in parts editor in icon view file->reuse breadboard image. As well in schematic the connector terminals aren't defined in the svg so the connector is defaulting to the middle of the pin:
Image may be NSFW.
Clik here to view.
where it should be on the end of the pin as is the case with the connector. To fix this in parts editor (although I have never managed to make it work Image may be NSFW.
Clik here to view. ) you select the pin and set the direction (west in this example I think). In the svg and fzp file you define a rectangle (I usually use .01 as the size), place it on the end of the pin (connector15pin in this case) and call it connector15terminal. You then need to add a definition in the fzp file to specify a terminalid. Doing it via parts editor (which I suspect you are) is detailed in Old_Grey's video tutorials:
Peter
