Thanks Peter -
That is what I have done. I just does not have the "look" of a jumper that makes "following" the PCB layout a easier.
I will post the fzz file just for comments. It is a two board combination ... one in a lid with a 16x2 LCD and few LEDs and the mainboard in the bottom of the project box with the power input and sensor connections. I am using 2.5 mm stereo plugs to have remote sensors on three conductor cables about 25' long.
Not sure if this is the proper way of uploading a file, but if it does not work, perhaps someone may correct me.
Thanks again -
Jim
MRK1000 6_19_17 LCD board.fzz (9.9 KB)
MRK1000 6_19_17 Main board.fzz (52.2 KB)