Yep the upload worked fine. Ah the joys of single sided boards 
sometimes jumpers are the only answer on single sided, but in this case I think you can avoid it. Starting from the 2nd from left pin on the top row of the MKR1000 you could route a trace between the pins by the flow leds connector to connect to the tmp 36 connection that currently has the jumper. That probably assumes that the board is being made by a fab house rather than self etched to get the necessary clearance to go between the MKR1000 pins, but even self etching might work. Someone else may also see something I missed as I don't do boards all that often.
Peter