Try this one instead. I fixed a couple of problems, there was a translate in copper1 (which I just discovered a couple of days ago breaks putting the part on the bottom of the board), the holes were .040 where the datasheet wants .031 so I used the standard IC size of .035 and the pads were too close so I changed them to .068 (creating about twice the gap that it used to have at about 17 thou):
edit: updated the meta data so that it shows up in Inspector better (as type -top with its Molex part number). So you may want to redownload if you grabbed this already, although the only change is the metadata):
RJ11 Jack_top_fixed.fzpz (8.2 KB)
Peter