Creating QFN-24 3.5mm x 3.5mm

Hi Vanepp, Thanks again for the advice. I can use both methods to solder. Personally i was about to use the solder paste + heat gun method as that worked for me before with the breakout board. And for the current design, i have requested for production already , but its with a silk screen. So this should prvent any kind of solder bridges. The trickiest part to solder is definitely the QFN 24 chip. I tried to make the connections as straight as possible. I somehow missed to see the bent connections at the pads. Thats a bit upsetting for me. I have sent the PCB for manufacture which should arrive for july 13th. I hope i can give a good results

image.png948x677 39 KB