The connector0terminal usually has no color, no fill or lines... in other words, it is invisible. It can be a line, square, circle, etc. The wire will snap to the center... the middle of a line or the center of a square or circle. The square seams to be the most common but I have done them with all the above. I like the square because in CorelDraw, object manager it is easy to identify next to the connector0pin, (curve). Sometimes they are 0,0 and you can't do anything with them, even in CorelDraw... I just copy the name (connector0terminal), draw a new square and past the name in it. Sometimes I make them the width of the pin (about 0.03") or 0.01", 0.02" doesn't make any difference... When there is anything weird... like it would be centered on the connecor0pin node in CorelDraw, but in FZ it was offset... I would just delete it and draw a new one. You don't know where these drawings come from and some of them are pretty wired... delete and redraw...
↧