Does an Arduino Uno Mega Shield SD Card ICSP SPI Exists Already?

Hi Peter,
This is not working in my scenario for some reason. Can you see what is wrong?

I ordered this part - https://www.mouser.com/ProductDetail/595-SN74AHC125NE4

Here is my schematic -

Image may be NSFW.
Clik here to view.

schem1.JPG809x747 105 KB

The pins are the bottom represent the Arduino UNO pinouts… Top left is CS, Pin 10. Bottom is 3.3 V. Just noticed I am missing the ground symbol but everything is grounded.

UPDATE: I have separated the VCC input on the chip (now goes to +5) and sd card reader (stays at 3,3).
Before, both were being powered from the 3.3.

The result is no change; it still doesn’t work. Image may be NSFW.
Clik here to view.